Important Safety Advice - EFALOCK Professional EASY STRAIGHT BRUSH Bedienungsanleitung

EFALOCK Easy Straight Brush
Thank you for purchasing a product from EFALOCK Professional. To ensure a proper and
safe use, please read the instructions carefully and always take into account. This manual
supplies information for the correct and safe use of the device.
We hope you enjoy using your new EFALOCK Easy Straight Brush and that you find it plea-
sant to work with:
- straight hair in seconds, trough combing only
- enjoyable scalp massage
- precise temperature control through digital display
- suitable for all hair types
- quick heating up, easy operation
USER INSTRUCTIONS
To switch the Easy Straight Brush on insert the plug into a socket and press the on/off but-
ton for 3 seconds. Change the temperature setting in 10° C steps through pressing the "+"
and "-" buttons accordingly.
We recommend the following temperature settings:
1. 210-230 °C for strong to coarse hair
2. 190-210 °C for normal hair
3. 170-200 °C for fine and chemically treated (coloured/permed) hair
An optimum and constant operating temperature is guaranteed after a stabilization period
of approx.. 2 –3 minutes.
To switch the device off press the on/off button again for 3 secosnds and then take the plug
out of the socket. The appliance is equipped with an auto-off function that turns it off after
1 hour. To continue using the appliance turn it back on.
USE
1. Comb your dry hair with a wide toothed comb
2. Comb your dry hair section for section with the preheated Easy Straight Brush carefully
and slowly. For best results repeat procedure 2 to 3 times.
3. For optimal results do not use sections that are too thick.
CLEANING
Please note: only clean the Easy Straight Brush when it has cooled right down!
Take the mains plug out of the socket. Wipe down the outer casing of the device with a
slightly moistened cloth. Do not let any water or other liquid trickle on to or into the device.

IMPORTANT SAFETY ADVICE:

Before using the Easy Straight Brush it must be checked that the calibration of the elec-
tric current of the device is compatible with the socket. Basic safety precautions must be
taken when using electrical devices – especially when children are around – including the
following: All the advice on safety should be read most carefully before use in order to limit
the risk of an electric shock.
14101835_USE_English.indd 1
ENGLISH
1. Unplug the device after using it.
2. The device must not be used in the bath, in the shower, above a washbasin filled with
water or with wet hands.
3. Do not use the device near baths, washbasins or other receptacles containing water.
4. The device must not be submerged into water or other liquids.
5. Do not touch a device that has come into contact with water – unplug it immediately.
WARNING – to limit the risk of fire, death by electric shock, fire or personal injury:
1. Never leave the device unsupervised when it is switched on. Always wait until the de-
vice has cooled off.
2. Great care is necessary when the device is used with or for children or when children or
disabled persons are nearby.
3. The device must not be used for purposes for which it is not intended.
4. Do not use any individual parts that are not recommended or sold by the vendor.
5. Keep the service cable away from hot surfaces. Check frequently for damage, especially
to the points at which the cable is joined to the device and the plug. If in doubt have the
device checked by an authorised repair workshop.
6. If the device is not functioning correctly, has been dropped or damaged, or has fallen
into water – do not try to open the device yourself, but take it to a customer service
point.
7. The device is hot when it is being used – do not allow it to come into contact with bare
skin. Do not touch the heating plates with your fingertips.
8. Do not wind the service cable around the device – leave it extended.
9. If the device's mains connection cable is damaged it must, in order to avoid danger,
be replaced by the manufacturer or its customer service provider or by some similarly
qualified person.
10. If the device is used in a bathroom it must be unplugged after use because the proximi-
ty of water constitutes a danger, even when the device is switched off.
11. As an additional protection we recommend the installation in the bathroom wiring sys-
tem of a residual current circuit breaker (FI) with a rated tripping current of not more
than 30 mA (Milliamperes). Ask your plumber for advice.
12. People (including children) who are not in a position to use the device safely because
of their physical, sensory or intellectual capabilities or because of their lack of experi-
ence or knowledge should not use this device without supervision or instruction by a
responsible person.
Children should be supervised to ensure that they do not play with the device.
WARNING: Do not use this device near baths, washbasins or other recep-
tacles that contain water.
EASY STRAIGHT BRUSH
25.02.16 11:21