EFALOCK Professional CLASSIC STYLE Bedienungsanleitung Seite 11

Adjustment of the cutting length using attachment combs.
The attachment combs can be placed on the cutting head for different
cutting lengths. These are supplied with the device, in sizes
1.5/3/4.5/6/10/13mm. (5).
These are placed on the device with the help of a magnet in the attachment comb.
Cleaning and maintenance.
To maintain the optimum cutting performance of the appliance, you should regularly
maintain the device. The best thing is cleaning and oiling every day.
 Switch off the device and disconnect it from the mains.
Remove the comb attachment from the cutting head, if in use.
Remove all hair and other contaminants with the supplied brush.
Carefully remove the cutting head from the device. (If possible)
Oil the cutting head; if you use the device regularly, we recommend that you do this before each use.
Oil all the parts of the cutting head that contact each other.
Only use the special oil supplied with the device (do not dilute, it will not hinder the course of the
cutting head). Health hazard due to care oil! Store the filled oil bottle out of reach of children.
Do not swallow! Avoid eye contact. Dispose of empty. To clean the housing of the device, you can
use a slightly damp (not wet) cloth. Do not use aggressive or abrasive cleaning agents when cleaning
the device. If the cutting head takes less hair after a while, it can be replaced with a new original one
(available as a spare part from EFALOCK).
Cleaning the cutting head/Changing the side lever and/or making it infinitely adjustable
Step 1: Loosen both screws counter clockwise and take off the cutting blades. Leave the plastic part,
including spring, in place.
Step 2: Just unscrew the right screw. This is to block the nut, so that you can loosen the screw of the
side lever without it spinning.
Step 3: Remove the screw from the side lever by unscrewing it counter clockwise and put it next to
the device.
Step 4: If you want to remove the click system, to be able to work continuously, remove the part that
you see circled. Keep this safe!
Step 5: Replace the side lever and make sure to screw it back to the correct tension. Test this out by
moving the side lever up and down. This varies per person, but make sure it is not too tight or
too loose.
14102363_Classic Clipper_black_im-Umweltzeichen.indd 11 14102363_Classic Clipper_black_im-Umweltzeichen.indd 11
11
ENGLISH
02.11.22 14:49 02.11.22 14:49