Error Code - HAGOR STM Motorized Cisco WebEx Board 70 Installationsanleitung

Errors & Solutions
No.
1
2
3
4
5
6
7
HAGOR Products GmbH | Oberbecksener Straße 97 | D-32547 Bad Oeynhausen | Telefon: +49(0)57 31-7 55 07-0 | Mail: info@hagor.de

Error Code

Hot
RESET
E01 / E02
E06
E07
E08 / E09
E10
Solution
1.1
Wait 18 minutes.
1.2
Plug out power cable (until handset without display)
then plug the power again. The error code will auto disappear
When the handset displays "RES", reset is required. Press
and hold the down button, after 5 seconds the desk will begin
to lower, until to the lowest height then slightly rise. Reset
finished. Release the down button.
2.1
Please check the cables and make sure there are connected.
Then waiting 3 seconds, the error code will auto disappear.
2.2
Waiting 3 seconds, the error code will auto disappear.
If not disappear, Contact supplier.
2.3
Remove over weight, then code will auto disappear.
When the handset displays "RES", reset is required. Press
and hold the down button, after 5 seconds the desk will begin
to lower, until to the lowest height then slightly rise. Reset
finished. Release the down button.
Please remove weights to make sure
weight not over 45 kg
Only the service voltage rise to product requirement,
then the error code will auto disappear
Insert handset after control box already have power.
Waiting 1 seconds, the error code will auto disappear.