Important Safety Instructions - Philips Lumea BRI948/00 Bedienungsanleitung

Important safety instructions

Warnings
-
Please read and follow these instructions to optimize the use of the device
and prevent/minimize the risk of injury, skin reactions and side effects.
-
Before you use Lumea, you should clean your skin and make sure it is
hair‑free, entirely dry and free from any lotion or gel.
-
Keep the device and the adapter dry.
-
This device is not washable. Never immerse the device in water and do not
rinse it under the tap.
-
Water and electricity are a dangerous combination. Do not use this
appliance in wet surroundings (e.g. near a filled bath, a running shower or a
filled swimming pool). Moisture can damage the device and lead to a
potential safety hazard.
-
Always check the device before you use it. Do not use the device or adapter
if it is damaged. Always replace a damaged part with one of the original
type.
-
If the device or adapter is broken or damaged, do not touch any inner part
to avoid electric shock.
-
Do not use the device if the UV filter of the light exit window and/or
attachment is broken, as safe operation cannot be guaranteed under these
circumstances.
-
Do not attempt to open or repair your device. Opening Philips Lumea may
expose you to dangerous electrical components and to pulsed light energy,
either of which may cause bodily and/or eye injury.
-
Always return the device to a service center authorized by Philips for
examination or repair. Repair by unqualified people could cause an
extremely hazardous situation for the user.
-
No modification of this equipment is allowed. Do not modify, override or cut
off any part of the device (e.g. adapter or the cord), as this causes a
hazardous situation.
-
Do not look at the flash while using the device. Use the device in a well-lit
room so that the light is less glaring to your eyes. While not necessary for
safety, you may wear sunglasses or goggles for your convenience if you find
the light uncomfortable or too bright.
-
Do not treat the same skin area more than once during a session. This may
increase the risk of skin reactions.
-
For hygienic reasons, the device should only be used by one person.
-
Do not use hair removal creams in the area (to be) treated with the device,
as chemicals may cause skin reactions.
-
Do not use any pencil or pen to mark the areas to be treated. This may cause
burns on your skin.
-
The device can be stored at a temperature between -25 °C and 70 °C. Use
the device at a temperature between 5 °C and 35 °C. The device will not
work properly outside of this temperature range. This may cause burns on
your skin.
9
English