Inhaltsverzeichnis
Werbung
Verfügbare Sprachen
Verfügbare Sprachen
I
-T
NSTALLATION
WEETERS
Wiring Tweeter to Crossover
1. Use illustrations for proper connection.
2. Be sure to maintain speaker polarity
Setting Crossover
A 0°/180° Tweeter Phase matches the phase response of the tweeter to the midrange (eminent
when tweeter is located away from the midrange). Leave the switch in the position that results in
the best sound quality.
B
0dB Tweeter Level matches the amplitude of the tweeter to the midrange
C -3dB/-6dB Tweeter Level reduces the amplitude of the tweeter -3dB or -6dB lower than the
midrange. (ex. ideal for tweeters located high in door panels and midranges located low in the
kick panel)
D Replaceable Tweeter Protection Bulb acts as a fuse to protect against overload. If the bulb burns
out, remove the burned out bulb and insert a new bulb (part# HDW10932) into the retainer
clips.
A
B
C
One Channel
from Source
or Amplifier
Tweeter or System Crossover
I
-S
NSTALLATION
PEAKERS
Use this section when installing Systems, Mid Bass, or 3-Way
1. Cut the proper size hole for the speaker.
NOTE: See Specifications for proper hole size.
2. Place the mounting ring over the mounting hole and mark the location of the screw mounting
holes.
6
Use this when installing Tweeters or Systems
D
Tweeter
Mid Range
Werbung
Inhaltsverzeichnis
