Chacon 34151 Bedienungsanleitung Seite 5

2.2. The status indicator turns red
When the gas concentration value in the air reaches the set alarm point, the detector enters
the alarm mode. An audible alarm of 85dB will sound and the status indicator will flash red.
Open the windows immediately and turn off the gas valve. Do not turn on or plug in any
electrical appliances. If the alarm does not stop, please leave your home, and call for help. If
necessary, ask your electrical and gas inspection expert to come and check your installation.
Note: In the alarm state, when the gas concentration is below the safe value, the detector
automatically disarms the alarm.
2.3. Failure warning
If the LED on the status indicator is yellow and lights up continuously and beeps, it means
that the detector is defective and cannot detect properly, please contact the distributor for
repair.
Tip: We advise you to check the device daily. To do so, please press the central button once,
the detector will enter the alarm simulation mode and will emit an audible and luminous
alarm signal, the red LED will flash and beep, then it will return to the normal detection state.
2.4. End of life warning
If the lifetime indicator flashes 3 times continuously and at the same time beeps 3 times, the
lifetime of the sensor has expired. Please contact your dealer if your warranty is still valid or
get a new sensor.
2.5. Device status summary
Mode
Preheat mode
Normal mode
LED indicator
Flashing green LED
Continuous green LED
Lifetime indicator
/
/
Alarm
/
/