Trouble Shooting - PACLITE Equipment M600NH Bedienungshandbuch

M600NH / M700 / M900 / M900-CC / M1200-CC
Engines
VANGUARD SAE 10W-3
GX160 SAE 10W-3
GX200 SAE 10W-3
GX270 SAE 10W-3
Gearbox
Note:
• Check the gearbox oil at regular intervals and top-up when necessary. Make sure the oil is at the centre of the
sight glass. To fi nd out what grade of oil should be used in the gearbox, please contact the Paclite Equipment
Warranty Department on +33 1 49 56 02 82.
• Grease Spider Arm Assembly prior to storage and at regular intervals.
Problems
Engine stops
suddenly or does
not run.
Disconnected
cutout safety
switch wir
Leaving swirls
in concrete;
rolling concrete;
bouncing.
14
Oil/Fuel type & quantity - Spark plug type
Quantity
Oil Type
(litres)
0,6
0,6
0,6
1,1
Small (0.35)
EP90
Large (0.6)

Trouble shooting

Possible Causes
1. No fuel
2. Engine switched off
3. Spark plug fouled
4. Engine cold
5. Engine fl ooded
Main shaft
Spider plate
Blades
Capacity
Fuel Type
(litres)
Unleaded Petrol 3,1
Unleaded Petrol 3,1
Unleaded Petrol 3,1
Unleaded Petrol 5,3
1. Open fuel cap, fi ll fuel tank
2. Switch engine on
3. Clean & reset plug gap
4. Close choke
5. Open choke, fully open throttle & pull recoil starter
until engine fi res.
When the machine has a
rolling motion, check the main shaft of the gearbox for
any abnormalities.
Check spider
If one is bent, replace it.
1. Check the trowel arms andensure all arms are
adjusted equally.
2. Blades should be of the same dimensions and
designed to fi t the machine.
3. Excessively worn blades should not be used.
Spark plug
Type
RC12YX
NGK BR-6HS
NGK BR-6HS
NGK BR-6HS
N/A
Countermeasures
Reconnect wire
plate for bent trowel
Electrode
Gap
0,6-0,7 mm
0,6-0,7 mm
0,6-0,7 mm
0,6-0,7 mm
arms.