Werbung
8
JIMS 45 PREAMP
Introduction
Congratulations on your purchase of the JIMS 45 PREAMP pedal. In this unit you will find a true-to-life
digital simulation of a 1965 Marshall JTM 45* tube amplifier, created using TC Electronics unique AMPWORX
modeling technology. Every detail of the original tube amp has been lovingly re-created in painstaking
detail by the TC tone technicians, right down to every last component in the circuit. Bringing you the best
digital amp modeling experience available.
*Marshall JTM 45 is a trademark or registered trademark of Marshall Amplification PLC.
Celestion CAB SIM
To provide you with a DI-ready pedalboard setup solution for connection to PA systems, recording interfaces
and headphones, we've partnered up with the best in the business and supplied you with an official
Celestion Digital impulse response of a 4 x 12 G12M Creamback loaded cabinet, so it's ready to roll right out
of the box via dedicated DI and Headphone outputs.
Custom MODS
What would a beautiful vintage tube amp be without a couple of hand-crafted boutique mods? We've added
some optional modifications, so you can tailor the pedal to your liking
• BOOST – JIMS 45 comes fully armed with a booster that can be engaged and disengaged via the BOOST
footswitch. On the back panel of the pedal you will find a PRE/POST toggle switch which will let you select
what kind of booster you want.
1. PRE – In PRE your booster will act like a vintage overdrive pedal stacked in front of your amp model,
providing more gain and a distinct mid hump. Perfect for solos and pushing the amp model, adding
more drive.
2. POST – In POST your booster will be a completely clean volume boost with no change to the tone or feel
of the amp model, it just gets louder.
Controls
NOTE: All controls on the back panel of the pedal
are global and not saved per channel. Intended to
"set and forget". **
NOTE: All controls values on the top panel of
the pedal and the BOOST footswitch status, are
independent per channel and save their settings
automatically when you switch between channels.
Quick Start Guide
9
1. IN – Connect your instrument to this jack
by using an instrument cable with a
¼" TS connector.
2. OUT – Outputs the amplifier model without
speaker cab sim. Connect to dedicated power
amplifier, amp FX RETURN, amplifier input or
external IR (Impulse Response) loader.
3. DI (CAB SIM) – Outputs the amplifier model,
combined with official Celestion Impulse
Response speaker cabinet for direct input to
audio interface, FRFR (full range) cabinet or
PA system.
4. PRESENCE – This control globally sets the
presence for both channels.
The PRESENCE 'set it and forget' knob allows
you to adjust the overall brightness of your
sound to suit your setup and outboard gear.
5. BOOST (PRE/POST) – This switch controls
whether the boost is applied before the amp
(PRE) for more distortion with +12 dB of gain
boost or after the amp (POST) for +4 dB boost
in volume.
6. DC IN – Connect to a standard 9 VDC /
300 mA power supply with center pin
negative connector.
7. USB – Connect to a computer using the included
mini-USB cable for firmware updates.
8. PHONES – Connect headphones with a 1/8"
(3.5 mm) stereo jack. Includes AMP MODEL
with CAB SIM.
9. NORMAL – Sets the gain for the amplifier
model's "normal" signal path.
10. HIGH – Sets the gain for amplifier model's
"bright" signal path.
11. LEVEL - Sets the output level with independent
control per channel.
Caution: AMPWORX pedals have a lot of output
level on tap.
Werbung
