EN
Important Safety Instructions
When using this product, basic precautions should always be followed:
1) Store this product in a cool and dry place.
2) Do not store this product in a hot or humid environment.
3) Using a power supply or charger not recommended or sold by the
product manufacturer may result in a risk of fire or personal injury.
4) Operating temperature should be between 32 to 95°F / 0 to 35°C.
5) Do not disassemble this product. Take it to a qualified service person
when service or repair is required. Incorrect reassembly may result in
a risk of fire or personal injury.
6) If this product is not used for an extended period, you should charge
and discharge it once every three months.
7) When charging a device, this product may feel warm. This is a normal
operating condition and should not be a cause for concern.
8) Under normal operating conditions, the battery performance will
decline over several years.
9) Do not expose the product to heat or fire.
10) Do not clean this product with harmful chemicals or detergents.
11) Misuse, dropping, or excessive force may cause product damage.
12) When disposing of secondary cells or batteries, keep those of different
electrochemical systems separate.
13) Beware that a discharged battery may cause fire or smoke.
14) CAUTION: There is a risk of explosion if the battery is replaced by an
incorrect type.
15) WARNING: The batteries (battery pack or installed batteries) shall not
be exposed to excessive heat, such as from the sun or fire.
16) A battery subjected to extremely low air pressure may result in an
explosion or leakage of flammable liquid or gas.
01 EN
Declaration of Conformity
Hereby, Anker Innovations Limited declares that this product is in
compliance with Directives 2014/35/EU, 2014/30/EU & 2011/65/ EU. The
full text of the EU declaration of conformity is available at the following
internet address: https://www.anker.com
GB Declaration of Conformity
Hereby, Anker Innovations Limited declares that this product is in
compliance with Electrical Equipment (Safety) Regulations 2016 &
Electromagnetic Compatibility Regulations 2016 & The Restriction of
the Use of Certain Hazardous Substances in Electrical and Electronic
Equipment Regulations 2012. The full text of the GB declaration of
conformity is available at the following internet address:
https://www.anker.com
Anker Innovations Limited
Room 1318-19, Hollywood Plaza, 610 Nathan Road, Mongkok, Kowloon,
Hong Kong
The following importers are the responsible parties (contracts for EU and
UK matters):
Anker Technology (UK) Ltd
GNR8, 49 Clarendon Road, Watford, Hertfordshire, WD17 1HP, United
Kingdom
Anker Innovations Deutschland GmbH
Georg-Muche-Strasse 3, 80807 Munich, Germany
This symbol indicates that this product shall not be treated as
household waste. Instead, it shall be handed over to the applicable
collection point for the recycling of electrical and electronic
equipment.
FCC Statement
This device complies with Part 15 of the FCC Rules. Operation is subject
to the following two conditions: (1) This device may not cause harmful
interference, and (2) this device must accept any interference received,
including interference that may cause undesired operation.
EN 02