Using Method - Tesla FS200 Bedienungsanleitung

USING METHOD

Kindly note that turn Water Flosser off and charge over 3 hours
before first use.
1. Insert nozzle into the center of the knob at the top of the
water flosser handle. You will hear a „click" once the nozzle is
corrently locked into.(Suggest to replace the nozzle every 3
months for better results. If the nozzle is loose or blocked by
foreign objects, it should be replaced).
2. Disconnect charging cable from the unit prior to filling the
reservoir and product use. Lift flip top on reservoir or take the
water tank, and fill the reservoir with lukewarm water.
3. Close the nozzle collection cover or rotate and locked the
water tank to prevent the water tank from overflowing.
4. Shortly press the mode button" „ to switch the flossing
mode.
Note: The device will keep same mode with last shutdown for
next working due to the memory function.
Standard Spray Mode: Holding the power button to spray
water, flossing after 1 second , and release the button to stop
spraying water.
Soft Mode: For the users with sensitive teeth or first time users.
Strong Mode: For the normal cleaning of teeth with most of
peoples.
Pulse Mode: Alternating strong and weak, deep cleaning, and
massaging gums.
Pressure Control: Water pressure adjustment. Low in Blue light,
Medium in White light, Strong in Orange light.
5. Shortly press the pressure control button" „ to switch the
intensity of the water spray.
6. Ensure the nozzle kept parallel to your teeth and gums.
Direct the jet stream at a 90-degree angle to your gumline.
Slightly close lips to avoid splashing but allow the water to flow
out into your sink.
7. Shortly press the power/flossing button, start flossing with
5