Goboservice DIVUM 50K Gebrauchsanweisung Seite 27

During the installation / replacement of a gobo inside a projector it is essential, for the correct
functioning of the same, to house the gobo so that THE MOST REFLECTIVE SIDE IS ALWAYS FACING
THE LIGHT SOURCE AND THE BLACK / GRAY SIDE AIMED TOWARDS THE OBJECTIVE (seeImage 9). The
respect of this rule allows the use of the gobos in a correct way avoiding their breaking.
Image 9
SOURCE LUMINEUSE LED GOBO OBJECTIF
Once you have understood the mounting direction, open the lower cover of the projector using the
special fixings, unscrew the fixing screws and remove the accessory from the body of the projector; the
gobo is supplied mounted on the ring nut and you simply need to place it on the gobo holder which has
magnets that support the ring nut, then reinsert the accessory and close the bottom cover of the
projector, also checking that everything is correctly mounted.
ATTENTION: Care must be taken not to damage, soil or stain the surfaces of the gobo, as this could lead
to visible scratches in projection or even chips which, with the heat developed during projection, could
lead to the gobo breaking.
The installation / replacement of the gobo must be carried out with the projector switched off and
disconnected from the power line.
Should the gobo need to be replaced after use, wait for the internal components to cool.
- 27 -
WWW.GOBOSERVICE.COM IST0006–Rev.0