Charging Process; Operation Of The Appliance - Team SH 1 Bedienungsanleitung

Fax +32 2 359 95 50

Never use the appliance with its adapter outside and always place it in a dry

environment.
When you decide to throw away the appliance, make sure to remove the battery and to

dispose of it in an ecological manner. For more information contact your town authorities.
BE CAREFUL NOT TO TOUCH THE ACCUMULATOR OR THE LEAKING LIQUID.

Competent qualified electrician: after-sales department of the producer or importer or any
(*)
person who is qualified, approved and competent to perform this kind of repairs in order to
avoid all danger. In case of need you should return the appliance to this electrician.
CHARACTERISTICS OF THE ADAPTER
Your appliance is delivered with an adaptor, and if you have to replace it, we advise you to
call in the nearest customer service or, in case of emergency, to pay attention to the following
characteristics:
 Voltage: make sure to respect the voltage of the country you are using the
appliance in.
 Voltage supplied: 3Vdc
 Current intensity: 300mA
We accept no liability for damages resulting from non-observance of this paragraph.

CHARGING PROCESS

Do not charge your appliance if the room temperature is below 0°C or above 40°C.
Never charge your appliance more than 24 hours.
The average charging time of your appliance is 4 hours.
We advise you to charge your appliance fully before the first use and to let it discharge itself
regularly afterwards in order to increase the battery's lifespan. When you do not use the
appliance for a long time, it is perfectly normal that the battery discharges itself.
 Put the plug of the supplied adapter in a power outlet with a voltage between 220 and
230V~.
 Put the other end of the adapter's cord into the appliance. If you use another adapter
than the one supplied, make sure it possesses the same characteristics as mentioned
above.
 As soon as the adapter is connected to the shaver, the red pilot light will come on.
 Once the appliance is fully charged, you just need to remove the plug from the power
outlet.

OPERATION OF THE APPLIANCE

Before use, we advise you to take a warm bath or shower in order to soften your skin and open
up your pores. Make use of cosmetics especially made to prepare your skin to make shaving
less painful. After use, you can use cream to soften the possible irritation of the skin.

When the appliance is correctly charged, remove the protective cap (4).

Slide the switch (2) upwards. The appliance starts to operate.

Make a rotary movement against the skin and press a bit harder on difficult areas.

To finish off the shaving, e.g. to cut the moustache and the side-whiskers, you can use the
long hair trimmer (9) situated at the back of the appliance. To switch it on, slide its release
button (8) upwards. When it reaches the correct position, it will switch on automatically.

Put the blade of the long hair trimmer (9) at a 90° angle against the surface you want to
shave and press gently.

To stop the trimmer, slide it back to its initial position.
Copies of the I/B. Please reproduce them without any
changes except under
International BELGIUM. The pages must be reproduced and
folded in order to obtain a booklet A5 (+/- 148.5 mm width x
210 mm height). When folding, make sure you keep the good
numbering when you turn the pages of the I/B. Don't change
the page numbering. Keep the language integrity.
9
Assembly page 9/32
special instruction from
TEAM SH 1 - 091201
Team