PNI SH101 Benutzerhandbuch Seite 5

Installation
» Remove the front panel with a screwdriver.
» Connect the wires according to the diagram
above.
» Fix the switch in the wall box.
» Mount the glass panel (pressing from top to
bottom).
» Turn on the electricity supply.
» Wait 10 sec. then test the touch button.
Troubleshooting
» The bulb light glows dimly or flickers.
If the bulb does not light up, lights up weakly
or flickers, please connect the yellow capacitor
between the neutral wire and the line wire
according to the diagram below:
N L
User manual - 5