Inhaltsverzeichnis
Werbung
Verfügbare Sprachen
Verfügbare Sprachen
8
8. ANALOG OUTPUT:
analogue audio signal outputs
Either the RCA connector pair or the XLR socketss
("BALANCED") must be connected to the corre-
sponding input of the amplifier, preamplifier etc.
9. LAMP: Dimmer for the tube illumination
The setting of this switch affects the brightness of
the illumination of the tube display window (5).
10. POWER CONTROL (12V)
These jack connectors (3.5 mm) send the signals
for the standby control (12V Trigger).
11. DIGITAL IN:
USB: input connector
Here you can connect a PC, laptop etc. by a USB
B/A cable.
12. DIGITAL IN:
AES/EBU + Coaxial 1 & Coaxial 2
Connections for audio signals of source devi-
ces with digital sound such as, for example,
DVD players. "Coaxial" for connection via
coaxial cable and "AES/EBU" via symmetri-
cal XLR cable.
13. DIGITAL IN:
Optical 1 / Optical 2
Connections for audio signals of source devices
with digital sound via optical fibre connection.
Vincent
28
REAR VIEW
11
9
10
12
13
14. Voltage Selector:
The voltage selector behind the pane allows swit-
ching the voltage from 230 V to 110 V.
Refer to safety instructions for further information
(p. 32, "Switching the Voltage")
15. AC 220-240V: Power Connector
To establish the power supply, connect the plugs
of the power cable to the device and to a suitable
wall outlet.
16. AUTO: Automatic shutdown in terms of
eco design regulation
If the unit is in non-use, this device switches off
after about 15 minutes. It will then have a power
consumption of less than 0.4 W. In order to
switch on the device again, press the power but-
ton 1 time. This function could be completely swit-
ched off by putting the switch „Auto" at the back-
side of the unit to „Off". This device has no stand-
by or armed state. If you intend not to use the
device for a longer period of time it is recommen-
ded to plug it off from the mains.
14
15
16
Werbung
Inhaltsverzeichnis
