EUROM Golden 2000 Giant Gebrauchsanleitung Seite 26

To do this, loosen the first Allen screw with the Allen key and pull the pin with
the other screw out of the screw hole. Place the suspension bracket with the
round parts of the bracket between the two screw holes as shown.
Make sure the correct side is pointing up. The text "This side up" is printed on
both the bracket and the
radiator. In the correct position
the radiator's electrical cable
will lead downwards.
Push the pin with the second
screw back through the screw
holes and the mounting
bracket. Replace the first Allen
screw and tighten securely
with the Allen key.

Pay attention to the mounting
place for your
appliance has to be mounted on
an incombustible
That foundation
vibrationfree, exact vertical and stable enough for lastingly holding the appliance
free of problems. Check or the provided (anchor bolts) are suitable, strong enough
and qualified for the foundation. The material provided is identified for a brick wall;
for another foundation please ask the specialist for suitable material.

Check before mounting or the minimum safe mounting distances between heater
and environment are strictly followed. The distance between the bottom edge of
the appliance and the floor must be at least 1,8 meter. There must be a distance
of at least 0,25 meter between the appliance and the ceiling, roof or other cover.
There must be a distance of at least 0,5 meter at each side between the appliance
and walls or the like. When you install the appliance outside, pay attention that it
doesn't catch excessive wind load.

The recommended downwards tilting angle is 45°. The infrared heater must never
be directed to the ceiling to prevent overheating of the ceiling.

Attach the Golden Giant to the wall. The Golden Giant can be attached to the wall
in two ways:
A. Semi-permanently by means of the wall support
B. Permanently by attaching it directly to the wall
A. Attaching to the wall using the wall support:
Attach the wall support (B) horizontally to the wall using the four cotter bolts
-
(C) included in the delivery.
Hang the terrace radiator in the wall support using the suspension bracket.
-
Slide the suspension bracket as far as possible through the wall bracket so
that the small hole in the suspension bracket winds up under the wall
support. Secure the terrace radiator by turning the wing nut (A) (included in
the delivery) as far as possible in the small hole of the suspension bracket
(A).
heater. The
foundation.
has to be
26