JBM 50911 Bedienungsanleitung Seite 4

ENG
MANUAL OF INSTRUCTIONS
FEATURE
• The hydraulic motorcycle lift is operated by one pedal for the lifting and by another foot pedal for the release.
• After lifting, a spindle should be used to control lifting height, to prevent unintentional slow lowering.
• With the leading plate, the motorcycle can be easily moved onto the platform.
• A locking front wheel should be used to prevent the motorcycle from slipping, tilting over or falling.
ALWAYS lower the platform before move on the motorcycle
• The motorcycle lift should be anchored to the floor with two adjusting screws to prevent it from sliding.
• The hydraulic motorcycle lift can be moved easily with four wheels.
• The Motorcycle lift has a floating wheel's brake, to avoid unexpected movement.
ALWAYS fix the platform before start work
• Move the motorcycle lift by pulling or pushing the handle on the rear edge of the platform.
CAUTIONS
• Never use the tool to lift people or animals.
• Keep children away. Children must never be allowed in the work area. Do not let them handle machines, tools or extension cords.
• Keep animals away. Animals can cause damage or failure of the lift and may result in personal injury.
• Keep work area clean. Cluttered areas invite injuries.
• Before operating, be sure to fix the motorcycle lift on floor with adjusting screws to prevent the lift from sliding during operation.
• Never touch the scissor arms if the tool is lifting or moving.
• After putting the motorcycle on the platform, be sure to lock the front wheel of the motorcycle using vise to prevent it from slipping,
tilting over, or falling.
• After lifting, be sure to insert the set spindle into the front lifting arm to prevent unintentional slow lowering.
• Observe work area condition. Do not work in damp or wet locations. Don't expose to rain.
• Keep work area well lighted.
• Do not overload the lifter capacity (max 365KGS). Overloading can cause damage or failure of the motorcycle lift, and may
result in personal injury.
• Store the equipment. When not in use, tools must be stored in a dry location to avoid rust. Always lock the tool in the lowest
position and keep it out of reach from children.
• Use eye and ear protection.
• Do not overreach. Keep proper footing and balance at all times. Do not pass over or across electrical cables or frames.
• Use the suitable tool for each job. Do not use damaged tools or tools for different purpose for which it is made.
• Stay alert. Watch what you are doing, and use common sense. Do not operate any tool if you feel tired.
• Dress properly. Do not wear loose clothing or jewelry, as they can be caught in moving parts. Non-skid footwear is recommended.
Wear restrictive hair covering to contain long hair. Always wear appropriate work clothing.
• Check for damaged parts. Before using any tool, any part that appears damaged should be carefully checked to determine
that it will operate properly and perform its intended function. Check for alignment and binding of moving parts, any broken parts or
mounting fixture, and any other condition that may affect proper operation. Any part that is damaged should be properly repaired or
replaced by a qualified technician. Check for oil leaks, and replaces pipes, valve or any damaged part.
• Keep maintenance. It is recommended that an annual inspection of the tool is made and that any defective parts, decals, or war-
ning labels are replaced by the manufacturer.
MACHINERY DRAWINGS AND PICTURES
REF. DESCRIPTION
1 Leading plate
2 Lifter floor
3 Motorcycle holder
Motorcycle holder's handle
4
5 Lift cylinder
· 4 ·
REF. DESCRIPTION
6 Scissor frame
7 Lifting pedal
8 Lowering pedal
9 Brake
10 Wheel