How To Use - Linea 2000 DOMO DO7091P Gebrauchsanleitung

DO7091P
GET TO KNOW YOUR IRONING BOARD GET TO KNOW YOUR IRONING BOARD
10
8
1
1. Ironing board
2. Feet
3. Air (intake/off/outward) switch 3. Air (intake/off/outward) switch
13
9
5
4. Power on/off switch
11 11
4
3
5. Power indicator
12
6. Rolling wheel
7. Non-skid rubber footings
8. Handle
9. Inro supprot
2 2
10. Iron support heat insulation
11. Height adjusting lever
6
12. Circulation fan
7
13. Power point base

HOW TO USE

How to Open
- Place the ironing board in a horizontal position (fi g. 1) and the iron support upwards;
drive the height adjusting lever and pull the feet outwards until the desired height is
reached.
- It is also possible to change the height of the ironing board according to the different
positions. All you need to do is pull the handle and adjust the ironing board to
position.
- The ironing board must be fi rmly supported on the ground.
- Place the iron on the iron support and plug the iron's feed cable in to power point b
base.
- Connect the plug of the iron into the mains. Make sure that the tension of the mains
is the same as that indicated on the feature plate on the device.
- Start the device by pressing on the power switch.
- Ironing Board gradually heat up (LED Power indicator will light up always)
- Simply by select air (intake/off/outfl ow) switch for airfl ow upward, airfl ow off &
airfl ow downward respectively
NOTE: After you have fi nished ironing, leave the ironing board plugged in for 3 or 4
Minutes, so as to ensure that there is no humidity trapped inside the board. This will
contribute to extend the board's life span.
HOW TO CLOSE
- Turn off the ironing board by pressing on the switch; Disconnect the iron from the
power point basis, disconnect the ironing board.
- Pull the handle to release the feet
- As soon as the ironing board is cold, place in vertical position with the iron support
15