Operating - Pfaff HU 26-115 TMt Betriebsanleitung

Hand pallet truck MOTION 26
English
Operating instructions
Functional description
The pallet truck is a manually-operated
hydraulic device.
The load is lifted by manipulating the pump
lever.
Easy manoeuvrability due to steering
rollers of solid-rubber resp. Polyurethane
and fork rollers of Polyamide resp.
Polyurethane.
The control lever in the handle can be set
to three different positions.

Operating:

Moving and steering using the steering handle
The steering handle is connected to the steering rollers. The wheels are steered automatically by moving the
steering handle.
Picking up a load
Check that the load does not exceed the
loading capacity of the pallet truck.
Roll the pallet truck slowly up to the
pallet/load. Roll the fork prongs under the
pallet until the back end of the fork rests
against the load (pallet). Lift the load by
executing the pumping movements shown.
Loading diagram
The load must be evenly distributed
across both prongs of the fork.
Moving with the load
As the pallet truck is not equipped with a
brake it must not be used on upward or
downward slopes.
As far as floor/ground clearance permits, the
load should be transported across the
floor/ground at as low a height as possible.
Move at a uniform speed appropriate to the
load and floor/ground conditions.
Setting the load down
Lower the load by applying the operating
lever in the handle.
Check that the way is not blocked behind,
then move the pallet truck away.
Subject to change without notice
F08.01.016/010
lowering
pump movement
Lowering position
driving
Driving position
lifting
Lifting position
page 8