Using The Device - Adler europe AD 2115 Bedienungsanweisung

because water proximity presents risk, even if the device is turned off.
15. Do not allow the device to wet. If the device falls into water, immediately remove the
power plug from the power socket. If the device is powered, do not put hands in the water.
Have the device checked by the qualified electrician before using it again.
16. Do not touch the device with wet hands.
17. The device has to be turned off after every use.
18. Do not leave device unattended when plugged in.
19. Keep the device out of the reach of children. Using the devices by children must be
supervised by adults.
20. The power cord should not touch hot parts of the device and should not be located near
other heat sources.
21. Do not wrap electric cable around the device.
22. Do not use the appliance in the bath.
23. Do not remove dust or foreign bodies from the inside of the device using sharp objects.
24. Do not use outdoors or where aerosols are being used or where oxygen is being
administered.
25. Do not cover the appliance, it might cause the accumulation of heat in its interior and it
may cause damage or fire.
26. Hairsprays contain flammable materials. Do not apply them while using the device.
27. Do not use the device on people who are sleeping.
28. During operation, do not put the device on a wet surface or on a surface that is sensitive
to heat and high temperatures.
29. After use, turn off and unplug the unit. Wait until the device cools down before storing.
30. The heating elements reach high temperatures during operation. Do not touch hot parts
of the device with bare hands and do not allow it to come into contact with the scalp, as this
may cause burns.
31. The device is not intended to be operated with external timers or a separate remote
control system.
DESCRIPTION OF THE DEVICE
1. On/Off indicator (LED diode)
4. On/off power switch
7. Cool touch tip

USING THE DEVICE

To achieve the best results in hair curling, use a device on washed, brushed and dry hair.
1. Before starting the electrical wire should be fully unrolled.
2. Insert the plug into the power socket.
3. Turn the unit on using the on/off switch (4). LED diode will flash (1).
4. Wait 1-2 minutes to allow the appliance to reach its working temperature.
5. Starting from the top of the head choose a small strand of hair and straighten it and comb.
6. Open the clamp (5) using the lever (6). Place the strand of hair so that the hair ends protrude slightly beyond
the clamp. Close the clamp (5).
7. Wind the hair strand around the barrel (3), starting at the hair tips and moving closer to the head.
CAUTION: Avoid touching the head skin with the curling iron – this may cause burns.
8. For heavy curl effect, keep the strand of hair wound around the curling iron wand for +/- 10 seconds or for a
shorter time for light curls or crimped hair.
9. After use, switch the iron off with the on/off switch (4), then unplug it from the power source.
2. Handle 3. Ceramic coated barrel
5. Clamp 6. Lever
8. Stand 9. Swivel cord
4