Range Of Use; Technical Data; Scope Of Delivery; Commissioning - T.I.P. TSS INOX 1600 Gebrauchsanweisung

2. Range of use

This product is intended for private use in the home area and not for commercial or industrial purposes.
Use the appliance only for cleaning and removing foliage and mud in ponds.
The pump is not suited to discharge saltwater, faeces, inflammable, etching, explosive or
other hazardous liquids. Please observe the max. and min. temperatures of the liquids to be
discharged stated in the technical data.

3. Technical Data

Model
Mains voltage / frequency
Nominal performance
Connection cable
Suction height max.
Tank size
Suction hose
Drain hose
Temperature medium max.
Noise level guaranteed
Weight (net)
Article No.

4. Scope of delivery

T.I.P. pond cleaner, suction hose, 4 suction pipes, suction sludge nozzle, closure cap, suction filter, drain hose,
filter for waste water, rolls, replacement O-Ring for outlet opening, instruction manual.

5. Commissioning

Possible operating conditions:
(-) MAN: Continuous operation (NOTE: please consider 40 sec than shut off the motor to empty the tank).
(0) OFF: The machine is switched off
(=) AUTO: Automatic suction and emptying mode with short switch-on delay. After a working interval of approx.
40 seconds, the pond sludge suction device switches off for approx. 40 seconds.

Check that the switch is set to (0) OFF. It is recommended to connect the device to a circuit with a residual
current circuit breaker.
Assembly
1) Place the feet's (K) under the unit to ensure the distance to the ground. The slight increase by means of the
feet prevents the drain hose from being pushed upwards by the pressure of the floor and thus possibly losing
the hold in the opening provided.
2) Attach the discharge hose (C) to the discharge opening of the collecting container (I) by using the hose end in
which the already installed check valve is located.
3) Place the outlet filter (D) over the other end of the drain hose (C) and secure it with the cord.
4) Insert the suction hose (L) into the opening of the suction nozzle (H).
5) As required, plug the extension tubes (M) together (up to 4 pieces, the transparent one serves for the visual
inspection of the water flow) and connect them to the suction hose (L).
6) Insert the pond sludge nozzle (O) onto the last extension pipe (M).

Ensure that the drain hose (C) is placed so that the discharged sludge water is transported to the desired
disposal location (for example, a collection container or drainage shaft). The drain hose must not be laid
ascending. The outlet filter (D) is usually installed at the end of the hose in order to retain coarse dirt particles.

Never use the appliance without the sponge filter (R) installed.

Insert the suction tube so deep into the body of the water until you touch the bottom with the pond sludge
nozzle (O).

Switch the switch (B) to (=) AUTO to switch the unit on.
TSS INOX 1600
230 V~ / 50 Hz
1,600 W
4 m / H05VV-F
1.8 m
32 liter
4 m (ø 35 mm)
2 m (ø 50 mm)
35 °C
91 dB
8 kg
30518
3
11