Inhaltsverzeichnis
Werbung
Verfügbare Sprachen
Verfügbare Sprachen
UK
PLACEMENT OF INVERTER
The location where to install inverter must be:
Dry: Do not allow water to drip or splash onto it�
Cool: Ambient air temperature should be between 0 °C and 40 °C - ideally
between 15 °C and 25 °C� Do not place the inverter on or near a heating
vent or any piece of equipment which is generating heat above room
temperature� Do not place the inverter in direct sunlight unnecessarily�
Ventilated: Allow at least one inch of clearance around the unit for air
flow� Do not place items on or over the inverter during operation� Make
sure that air is allowed to circulate freely around the unit� A fan is helpful
in the case where the inverter is operating at maximum�
Safe: Do not install the inverter in the same compartment as the batteries
or in any compartment where flammable liquids or fumes may be or may
become present�
Dust: Do not install the inverter in a dusty environments� The dust can be
inhaled into the unit when the cooling fan is working�
Close to batteries: Avoid excessive cable lengths� Do not install the inver-
ter in the same compartment as batteries�
Mounting position of the inverter
The inverter may be mounted horizontally on the top of a horizontal surface
or under a horizontal surface� The inverter may be mounted on a vertical
surface only horizontally�
Getting Connected
Follow the connection sequence described below�
Step 1| Ensure that the ON/OFF switch on the inverter is in the OFF
position� If the power source is a DC power supply, switch it OFF
as well�
Step 2| Connect inverter to power source�
Connect the DC cables to the DC battery terminals on the rear
panel of the inverter� The red terminal is positive (+) and the black
terminal is negative (-)�
Step 3| Connect inverter to appliances�
Make sure the load power within the rated power of inverter and
the start power should not exceed the peak power of the inverter�
When having the inverter connected with appliances and a power
supply, switch on the inverter and appliances� If you are operating
several loads from the power inverter, tum them on separately
after the inverter has been turned on� This will ensure that the
power inverter does not have to deliver the starting currents for
all the loads at once�
Pure Sine Wave Inverter |
SI-1500/2000
17
82270/82271
Werbung
Inhaltsverzeichnis
