Inhaltsverzeichnis
Werbung
Your K'NEX Building Set includes Light-Up pieces specially designed to work
with the K'NEX system.
•
Inspect the Light-Ups components before each use. Do not use if insulation is cut, frayed or torn.
•
Do not put anything but the Light-Up Rods or K'NEX Rods into the sockets of the Light Module.
•
Keep all Light-Up Rods and Light Module components dry. Do not immerse in water.
•
Be sure to turn the Light Module switch OFF when finished.
•
Do not leave the Light Module on when not in use.
•
A slight humming noise is normal for the Light Module.
Test the Lights:
•
Insert 2 AAA (LR03) batteries into the Light Module and test your lights before building.
•
Plug the metal ends (contacts) of the Light-Up Rods firmly into the Light Module.
•
Turn the Light Module switch to the continuous ON and BLINK positions.
Lights not working?
•
Check to see if you have fresh batteries inserted with the correct polarity.
•
Check to see if the metal ends of Light-Up Rods are fully plugged into the Light Module.
(The ends with the metal tips must be inserted all the way into the Light Module to make contact.)
•
Turn the Light Module switch to the continuous ON or BLINK positions.
•
If the lights are still not working, call our Consumer Hotline at 1-800-KID-KNEX (USA and Canada only).
Or see page 5 for ways to contact us. We're here to help!
FCC Statements:
WARNING: Changes or modifications to this unit not expressly
approved by the party responsible for the compliance could void the
users right to operate the equipment.
This device complies with Part 15 of the FCC Rules. Operation is
subject to the following two conditions:
1. This device may not cause harmful interference and
2. This device must accept any interference received, including
interference that may cause undesired operation. This model is
tested to comply with FCC standards - FOR HOME OR OFFICE USE.
This equipment has been tested and found to comply with the limits
for a Class B digital device, pursuant to part 15 of the FCC Rules.
These limits are designed to provide reasonable protection against
harmful interference in a residential installation. This equipment
generates, uses and can radiate radio frequency energy, and, if not
installed and used in accordance with the instructions, may cause
harmful interference to radio communications. However, there is no
guarantee that interference will not occur in a particular installation.
If this equipment does cause harmful interference to radio or television
reception, which can be determined by turning the equipment off and
on, the user is encouraged to try to correct the interference by one or
more of the following measures: (1) Reorient or relocate the receiving
antenna. (2) Increase the separation between the equipment and
receiver. (3) Consult the dealer or an experienced radio/TV technician.
This Class B ditigal apparatus complies with Canadian ICES-003.
BLINK
OFF
ON
There are 3 switch positions
on the Light Module.
3
Werbung
Inhaltsverzeichnis
