Auxiliary Functions - Beko DS 8412 PA0 Bedienungsanleitung

Energy consumption values
Programmes
Cotton cupboard dry*
Cotton Iron dry
Synthetic cupboard dry
Power consumption of the off-mode for the standart cotton programme at full load, PO (W)
Power consumption of the left-on mode for the standart cotton programme at full load, PL (W)
Contains fluorinated greenhouse gases covered by the Kyoto Protocol.
Hermetically sealed.
"Cotton cupboard dry programme" used at full and partial load is the standard drying programme
to which the information in the label and the fiche relates, that this programme is suitable for drying
normal wet cotton laundry and that it is the most efficient programme in terms of energy consumption
for cotton.
* : Energy Label standard program (EN 61121:2012) All values in the table are determined
according to EN 61121:2012 standard. Consumption values may vary from the values in the chart
depending on laundry type, wringing speed, ambient conditions and voltage levels.

5.5 Auxiliary functions

Buzzer / time
Drying machine makes an audible warning
when the program is completed. If you don't
want the machine to make an audible warning,
press the "Buzzer / Time" button. When you
press the Buzzer/Time button, a light will
illuminate and no audible warning will be made
when the program ends.
C
NOTE
• You can select this function before or
after the program starts.
Buzzer/Time button is used to adjust program
duration while the Rack/Time programs are
selected.
Drying Level
Drying Level button is used for adjusting to
desired dryness level. Program duration may
change depending on the selection.
36
Capacity (kg)
8 / 4
8
4
C
•
End time
You can delay the end time of the program up
to 24 hours with End time function.
1.
2.
3.
4.
Spin speed
Approximate
in washing
amount of
machine
remaining humidity
(rpm)
1000
1000
800
R134a / 0,30 kg - GWP:1430 - 0,429
tCO2e
NOTE
You can activate this function only prior
to start of program.
Open the loading door and place the
laundry.
Select the drying program.
Press the End Time selection button and
set the delay time you wish. End Time
LED will illuminate. (When pressed and
hold the button, End Time proceeds non-
stop).
Press the Start / Stand-by button. End
Time countdown starts. ":" Separator in
the middle of displayed delay time flashes.
Energy
consumption
value kWh
60% 1,95 / 1,06
60% 1,5
40% 0,75
0,5
1,0
Dryer / User Manual