Basic Programming - Pentair Fleck 2850-SXT Bedienungsanleitung

3.3. Description and components location
3.4. By-passing
If the system is equipped with a bypass and if a problem occurs, turn the valves to bypass the system as shown in the picture
below.
Normal operation
Out
4 . Programming
Note:
The controller must be plugged to be programmed.
After 5 minutes without any button pressed, the unit returns to normal operation without saving.
4.1.

Basic programming

Note:
Menus are displayed in a defined and incremental order.
Day of Override
Note:
Determine the maximum number of days of operation without regeneration.
Regeneration time
A
Press and
B
Select the number of days of Override with
C
Press to validate the selection and advance to the next parameter.
Note:
Determine the time of regeneration.
D
Adjust the regeneration time with
E
Press to validate the selection and advance to the next parameter.
Ref. MKT-UG-030 / D - 16.01.2023
Regeneration button
Up button
Display
Down button
Meter
Softening System
In
simultaneously for 5 seconds to enter the menus sequence.
and
Drain
Outlet
Inlet
Brine
Out
and .
.
User Guide Fleck 2850-SXT
In Bypass
Softening System
In
6 / 36