Troubleshooting - TFA 60.2011 Bedienungsanleitung

TFA_No_60.2011_Anl_ 13.01.2012 10:08 Uhr Seite 8
Digital alarm clock with room climate
• Confirm the setting with MODE button.
• The month digit is flashing. Press UP or DOWN buttons to adjust the month.
• Confirm with MODE button.
• The day digit is flashing. Press UP or DOWN buttons to adjust the day.
• Confirm with MODE button.
• Press MODE button again to return to time mode.
7.3 Temperature display
• Press DOWN or °C/°F button to toggle between ° C or ° F as temperature unit.
7.4 Setting of alarm clock
• Press MODE button twice in time mode.
• appears on the display.
• Press and hold MODE button for 3 seconds.
• The hour digit and the alarm symbol are flashing. Press UP or DOWN buttons to
adjust the hours.
• Confirm the setting with MODE button.
• The minute digit and the alarm symbol are flashing. Press UP or DOWN buttons to
adjust the minutes.
• Confirm with MODE button.
• Press MODE button again to return to time mode.
14
• To activate the alarm press UP button.
• The current time and the alarm symbol appear on the display.
• Press UP button again and the alarm is disabled.
• The alarm symbol disappears on the display.
• When the alarm rings (4 different, increasing alarm levels), the alarm symbol flashes.
• You can stop the alarm by pressing any button.
• You can activate the snooze function by pressing the LIGHT/SNZ button on the base
or on the backside.
• The alarm symbol is flashing and the alarm will be interrupted for 8 minutes.
7.5 MAX/MIN function
• Press MAX/MIN button.
• MAX appears on the display. The highest temperature and humidity values appear
on the display.
• Press MAX/MIN button again.
• MIN appears on the display. The lowest temperature and humidity values appear on
the display.
• The MAX-MIN values are automatically reset at midnight.
• Press MAX/MIN button again to return to the actual display.
Digital alarm clock with room climate
7.6 Comfort level
On the display appears a Smiley to indicate the comfort level.
DRY < 40%
☺
OPTIMAL INDOOR CLIMATE 40 - 70% 20 °C...26 °C
WET > 70%
No display 40 - 70% <20 °C, >26 °C
8. Battery replacement on battery operation
• Replace the batteries when the display becomes weak.
• Open the battery compartment and insert three new batteries 3 x 1,5 V AAA. Ensure
battery polarity is correct.
9. Care and maintenance
• Clean it with a soft damp cloth. Do not use solvents or scouring agents. Protect from
moisture.
• Remove the batteries and pull out the plug of the socket, if you do not use the pro-
duct for a lengthy period.
• Keep the instrument in a dry place.

10. Troubleshooting

Problems Solution
➜ Connect unit to mains adapter
No display
Battery operation:
➜ Ensure batteries polarity are correct
➜ Change batteries
➜ Restart the instrument
Incorrect display
Battery operation:
➜ Change batteries
If your device fails to work despite these measures contact the supplier from whom you
purchased it.
15