Install Drivers; Laser Safety - Emulex PT1016 Schnellanleitung Und Benutzerhandbuch

All manuals and user guides at all-guides.com
PT1016PassThruModuleQSG.book Page 13 Monday, October 15, 2007 3:02 PM
Table 2. Pass-Through Module Status LEDs
Yellow LED
Off
Off
On
On
Off
Fast blink

4. Install Drivers

There are no drivers, fimware or boot code for this device. Utility
software, if applicable, will be located in the Support section of the
Emulex website (www.emulex.com).
5. Having Problems?
Notwithstanding language to the contrary in any other Dell
documentation or on any Dell website, the limited warranty applicable
to Dell branded products described in the Product Information Guide
and/or on the local country Dell website shall apply to the PT1016
Pass-Through Module.

6. Laser Safety

Install only CDRH Certified Class 1 Laser Devices.
PT1016 Pass-Through Module Quick Start Guide
and User Manual
Blue LED State
Off The pass-through module is
powered off or an error condi-
tion exists
On The switch is healthy
Off Switch fault
Off Booting up
Fast blink Chassis Management Con-
troller identifies pass-through
module
Off Misconfiguration on link
Page 13