Inhaltsverzeichnis
Werbung
gain for a different band).
Press the "INC+" key once briefly and the gain will increase by 1dB, Press "DEC-" once briefly and the gain value will
be reduced by 1dB.
Press the "SET" key for more than 3 seconds, and the LCD will return to the fixed display mode.
Note: When adjusting the gain manually, please ensure that the uplink gain is equal to or not less than 5dB compared
with the configured downlink gain values. This avoids interference with the local cell tower network.When the LCD is in
the fixed display mode, press the "DEC-" and "INC+" key simultaneously for more than 3 seconds, the booster will reset
the gain to the default manufacturer settings.
When the LCD is in the alarm display mode, press the "SET" key and the LCD screen will turn on to help with
troubleshooting and display the alarm indication showing the affected band or bands, press the "INC+" (or "DEC-") key
to switch to different pages.
If none of the keys are pressed within 30 seconds, the display will return to the fixed display mode. If none of the control
keys are pressed within 5 minutes, the LCD screen will turn off. Pressing any key will return the display to the fixed mode.
Install HiBoost Booster System
Before You Install
Make sure you have sufficient cable length between the outdoor,indoor antennas and the booster in case you have
not a standard kit.
Make sure the place where you install the booster is close to one of the existing electrical outlet. It should also be
well ventilated, away from excessive heat, moisture, and direct sunlight.
Installation Overview
Easy Installation in 4 simple steps
1. Find the strongest received signal for the location of the outdoor antenna
2. Install the outdoor antenna on the roof to obtain the strongest downlink signal from the local cellular towers It
should also be as far away as possible from where you plan to place the indoor antenna (vertical separation is more
important than horizontal separation).
3. Install the indoor antennas where you want to improve the signal level
4. Mount the booster, connect the cables from the outdoor antenna and indoor antenna at the designated ports, and
connect the booster to the AC supply (make sure all the cables are connected before applying power)
Installation Overview
1. Outdoor wide band Directional antenna
2. 50ft (15.2m) Hiboost200 low-loss cable
3. You can add an indoor panel/omni antenna and
50ft (15.2m)
Hiboost200 low-loss cable to extend the coverage
1. Outdoor wide band Directional antenna
2. 50ft (15.2m) Hiboost200 low-loss cable
3. Hiboost booster with built-in antenna
9
Werbung
Inhaltsverzeichnis
