Receipt Inspection; Preparation Before Use; The Use Of Oxygen Generator; The Use Of Nasal Oxygen Inhaler - VARON NT-3 Bedienungsanleitung

Receipt inspection

1. Check equipment and accessories
NO.
1
2
3
Disposable oxygen inhaler
4
External battery
5
Diagonal shoulder bag
6
Warranty card/certificate
7
8
Please check whether it is sufficient according to the above list. If there is any
missing, please contact the sales to make up the difference or return the goods.
Start using oxygen generator

Preparation before use:

1. Before starting the oxygen generator for the first time, please familiarize yourself
with the main accessories, which will be used later.
2. Instructions for use of the adapter and battery
(1) Due to transportation control reasons, the external batteries only retain the
power for testing when they leave the factory, or there is no power at all. Therefore,
the battery needs to be fully charged before the first use.
(2) Battery charging method:
a. Connect one end of the AC adapter to 100~240VAC, and the other end to the
charging socket of the battery. At this time, the AC adapter indicator lights up in red,
indicating that the battery is charging, and the battery is fully charged for about 4-6
hours; when the AC adapter indicates When the light turns green, it indicates that the
battery is fully charged. At this time, you can disconnect the AC adapter and the
battery.
b. Connect one end of the AC adapter to 100~240VAC and the other end to the
charging socket of the battery. At the same time, connect the output end of the battery
to the power input socket of the oxygen enrichment machine, and then press the
power switch of the oxygen enrichment machine to start the machine. Charge while
oxygen. In this mode, the time to fully charge the battery is related to the working
gear of the machine, and the time to fully charge is about 4-10 hours.
02 English
Name QTY
Main machine 1 unit
AC adaptor
1 set
1 pcs
Use manual
1 set
1 pcs
1 pcs
1 pcs
1 pcs
Car line

The use of oxygen generator:

1.Please place the product correctly, ensure that the air inlet and outlet are
unobstructed, and the distance from the outside to other objects or walls is at least
10cm;
2.Connect the oxygen inhaler;
3.Connect the power input socket of this product to the output plug of the AC adapter
or external battery;
4.Press the power switch, the device will start the oxygen production of this product;
5.The product is turned on and enters the power-on state, and immediately starts
pulse oxygen supply. There are four timing time periods to choose from, 40 minutes,
60 minutes, 80 minutes and 180 minutes, and it will automatically shut down when it
is used.

The use of nasal oxygen inhaler:

1.Connect one end of the oxygen inhalation tube to the nasal inhaler and the other
end to the oxygen output port of the device.
2.When using the oxygen inhaler, the tube must be connected correctly and not
folded, so as not to inhale oxygen normally;
3.See the following

Specific operation:

1.Take out the oxygen generator and insert the output plug of the power supply or
battery pack into the power socket of the oxygen generator. If it is from a low
temperature environment to a room temperature environment, it needs to be placed
for 4 hours before performing this operation, such as from outdoors-100C gets indoor
200C, it needs to be placed for 4 hours before use.
2.Standard battery pack
On the left is the charger socket. The rubber cap should be fastened
when not in use to prevent short circuit damage to the battery or
accidents.
The one on the right is the output line, which can be plugged into
the power socket of the oxygen generator to supply power to the
oxygen generator.
3.Take out the nasal suction tube and insert the air inlet of the
nasal suction tube into the air outlet of the oxygen generator;
The upper one is the air outlet connector, the lower one is the power socket,
which can be connected to a battery pack or a power adapter
English
03