Tool it PBT 812 Bedienungsanleitung Seite 16

Operating manual
REPLACE / INSTALL THE AA BATTERIES
REPLACE / INSTALL THE RECHARGEABLE 18650 LITHIUM BATTERIES
16
Translation of the original
instructions
3. Unscrew the battery cover to access the battery compartment.
4. Pull the strap up to remove the AA batteries and install new ones (Always keep
the strap under the batteries.)
5. Close the battery cover and tighten the screw.
1. Unscrew the battery cover to access the battery compartment.
2. Install / Replace the 18650 lithium batteries from the battery holder.
3. Plug in the connector of the 18650 lithium battery holder.
4. Place the 18650 lithium battery holder in position. (Always keep the strap un-
der the battery holder.)
5. Close the battery cover and tighten the screw. (Make sure the battery cover
doesn't clip on the cables of the battery holder when closing.)
6. Tighten the srew of the battery cover.
*18650 lithium batteries are not included in the package.
PBT 812