Cleaning And Mainenance - Ideen Welt M3800 Bedienungsanleitung

DRY SHAVING:
While dry shaving, your skin is dry. Guide the shaving head carefully over the skin. Pressing it
too hard may cause cut-wounds and also damages to the device.
Thanks to the two-sided blades you can first shorten long hair or trim fine hair. In order to
remove the hair left after trimming, guide the trimmer over the corresponding places.
WET SHAVING:
Caution! The shaver must never be immersed in water.
Using the device for wet shaving rests basically on the same purposes as for dry shaving. Wet
shaving requires putting a thin layer of soap or shaving cream on the spot that you want to
shave. You should decide for yourself which method appeals to you more and brings better
results.
In principle, the manufacturer recommends dry shaving.

CLEANING AND MAINENANCE

Caution! Before each cleaning switch the device off by pressing the On/Off switch and remove
batteries from the battery compartment.
Caution! Do not use alcohol, acetone, benzene, abrasive cleaning agents, etc. for cleaning.
Important! Should the device not be used over a longer period, remove the batteries in order to
avoid damages.
You can remove the shaving head for cleaning. Detach it from the device using moderate
strength. Now you can wash it under running water. It is recommended to brush the shaving
head before cleaning it with water in order to remove the hairs and possible particles of dirt. It is
not recommended to blow the air in order to protect the eyes from particles. Wipe the shaving
head with a dry, not fluffy cloth.
Clean the area of the device where the shaving head is attached with the supplied brush and
remove the remaining particles of dirt with a dry or slightly dampened cloth.
The casing of the body of the device can be cleaned with a damp cloth. After cleaning, wipe the
device dry.
After cleaning, put a little bit of special grease on the swinging arm on which the shaving head
will be later placed. Special grease for body care products is available in specialist shops.
Consult a qualified person. Greasing reduces abrasion and prolongs the operational life of the
device.
In order to minimize abrasion and prolong the operational life of the blades, after cleaning the
shaving head, place a little bit of lubricating oil on the blades and the trimmer. Wipe off the
excess of oil with a cloth. After reassembling the device let it run briefly in order to distribute the
oil on the blades. Lubricating oil for body care products is available in specialist shops. Consult a
qualified person.
Reattach the shaving head onto the device. If the shaving head is locked in place properly, a
"clicking sound" will be heard.
Put on the protective cap in order to protect the shaving head.
Store the device and its accessories in the original packaging.
8