Inhaltsverzeichnis
Werbung
Verfügbare Sprachen
Verfügbare Sprachen
• Clean the front door interior surface and its
gaskets with a soft damp cloth or with the
brush on air routing cover.
6.2Cleaning the sensors
•
There are temperature sensor in the
dryer that detect whether the laundry is
dry or not.
To clean the sensors:
•
Open the loading door of the dryer.
•
Remove the lint filter by pulling it up.
•
Clean the sensor with your hand if any
fluff accumulation on it.
C
NOTE
•
Clean the sensor 4 times a year.
•
Do not use metal tools when cleaning the
sensor.
•
Allow the machine to cool down if it is still
hot due the drying process.
Dryer / User Manual
• Insert the fibre filters
on one another and
place it back in its
place.
A
WARNING!
•
Never use solvents, cleaning agents or
similar substances for cleaning due to the
risk of fire and explosion!
6.3 Draining the water tank
Dampness of the laundry is removed and
condensed during drying process and the
water that arise accumulates in the water tank.
Drain the water tank after each drying cycle.
A
WARNING!
•
Condensed water is not drinkable!
•
Never remove the water tank when the
program is running!
If you forget to drain the water tank, the
machine will stop during the subsequent drying
cycles when the water tank is full and the Water
Tank warning symbol will flash. If this is the
case, drain the water tank and press Start /
Pause button to resume the drying cycle.
To drain the water tank:
1.
Remove the water tank in the drawer
or container carefully.
2.
Drain the water in the tank.
•
If there is lint accumulation in the funnel
of the water tank, clean it under running
water.
•
Place the water tank into its seat.
45
Werbung
Inhaltsverzeichnis
