Parts And Components; Before Use; Installation - cecotec BOLERO COOLMARKET SBS 559 INOX E Bedienungsanleitung

ENGLISH

1. PARTS AND COMPONENTS

Fig. 1
1. LED light indicator
2. Door shelves (freezer compartment)
3. Shelves (freezer compartment)
4. Drawer cover
5. Freezer-compartment drawer
6. Refrigerator-compartment drawer
7. Egg storage container
8. Shelves (refrigerator compartment)
9. Door shelves (refrigerator compartment)
10. Water dispenser (depending on the model)
Note:
- The graphics in this manual are schematic representations and may not exactly match the
product.
- To make the most out of the refrigerator in terms of energy, place all the shelves and
drawers in their original position, that is, as shown in Figure 1.

2. BEFORE USE

- This refrigerator includes a packaging designed to protect it during transport. Take the
refrigerator out of the box. You can keep the original box and other elements in a safe
place, this will help you prevent product damage when transporting it in the future. In
case the original packaging is disposed of, make sure all packaging materials are recycled
accordingly.
- Make sure all parts and components are included and in good conditions. If there is any
piece missing or not in good condition, immediately contact the official Cecotec Technical
Support Service.
Levelling
- Make sure you level your refrigerator with the front levelling feet. If it is not levelled, the
refrigerator performance will be affected, or it can even cause a malfunction.
- After installing the refrigerator, wait 4 hours before using it to allow the refrigerant to
stabilise.
B O LE R O COOLM ARKET SBS 55 9 INOX E
60
B O LE R O COOLM ARKET SBS 55 9 DARK E
B O LE R O COOLM ARKET SBS 55 9 GLASS E

3. INSTALLATION

- The location you choose for the refrigerator must be properly ventilated and away from
heat sources. Do not place the refrigerator near heat sources, like a cooker, and avoid
direct sunlight to ensure the cooling effect and save on energy consumption. It is not
recommended to place the refrigerator in a wet place, as it may rust and cause electrical
leakage.
- During operation, the refrigerator releases heat into the environment. Therefore, you
should leave at least 300 mm of free space at the top, more than 100 mm on both sides,
and more than 50 mm at the rear of the refrigerator.
Height
Width (mm) Depth (mm)
(mm)
912 704 1770
Fig. 2
Please note
Figure 2 only illustrates the space required for the refrigerator.
Stable surface
- Place the refrigerator on a solid, flat surface to keep it stable, otherwise vibrations and
noises will occur.
- Ensure a ventilation free of obstacles around the refrigerator.
Preparing for use
Waiting time
Once the refrigerator is installed and clean, do not turn it on immediately, wait at least 4 hours
before connecting it to the power supply.
Cleaning
Check the position of the shelves and drawers in the interior of the refrigerator and clean the
interior with a soft cloth.
Switch-on
Connect the plug into a power socket to switch on the refrigerator. After one hour, open the
freezer compartment door: if the temperature inside the freezer compartment has dropped,
the cooling system is running normally.
BOLERO COOLMARKET S BS 559 IN OX E
B OLERO COO LMA RKET SBS 55 9 DARK E
BOLERO COOLMARKET S BS 559 G LA SS E
ENGLISH
A (mm) B (mm) C (°) E (mm) F (mm)
1524 1062 160 50 100
61