Led Indication; Product Overview - Chuango RT-101 Bedienungsanleitung

EN
Introduction
The repeater is a wireless signal relay transmission device.
With MCU technology, it can decode the signal in the air and
strengthen the transmitting power to extend the transmission
distance range. Failure to receive signal to panel from wireless
accessories is frequently happened due to the long distance range
when the remote controlling or wireless alarm systems are applied
to large scale of commercial tall buildings, villa, and industrial
areas. This wireless signal repeater could solve this problem and
further distance range signal transmitting could be achieved.

Product Overview

Antenna
Interface for
External Antenna
Note: Please pull out the antenna for optimal performance.
Power ON/OFF Learning Button

LED Indication

Green LED on: working status
Blue LED flashes once: signal transmitting
Green and blue LEDs flash alternatively: in connect status
Adding and Deleting Accessories
Before adding and deleting accessories, make sure the repeater has
been activated to 'connect status'. To activate connect status, you
need to turn 'power' button to 'ON'; if it is already in 'ON' mode,
reboot the repeater from 'OFF' to 'ON'. Indicator light will then
alternately flash between green and blue. Choose following options
to add or delete accessories:
Extend Transmission Distance between Accessories and Control Panel
First, press the 'Learning Button' upon the repeater, you will hear a
short beep. After that, you can trigger any accessory you wish to pair
to the repeater, for example, separates two components of door/
window contact; if the repeater is successfully paired, a two-second
length "beep" will sound with blue light on, and light will alternately
shining between blue and green. You may add more accessories by
repeating the steps above.
Note: If the repeater does not receive any signal within one minute, the pairing
process will be canceled, it would sound beep twice meanwhile. If the repeater
exits the connect status, switch off and then switch on the repeater to re-enter the
connect status. Then repeat the above operation to add more accessories.
EN