Chamberlain TX4RUNI Bedienungsanleitung Seite 5

WARNING
Activate opener only when door/gate is in full view, free of obstruction and properly adjusted. No one should enter or leave while door/
gate is in motion. Do not allow children to operate push buttons or remote controls. Do not allow children to play near the door/gate.
Risk of explosion if the battery is replaced by an incorrect type.
Do not ingest battery, Chemical Burn Hazard.
This product contains a coin battery. If swallowed, button batteries can cause injuries, or death.
WARNING
• Keep batteries out of sight and out of the reach of children, button/coin batteries can be dangerous for children.
• Dispose of used button batteries immediately. Do not use defect/swallowed batteries.
• Check periodically if the battery compartments is secure, stop using if defect.
• If batteries might have been swallowed or placed inside any part of the body, seek immediate medical attention.
The universal remote control works with most 433Mhz Chamberlain, Motorlift or Liftmaster garage door openers, gate opener controls and
external receivers except LM50K, ML510 and HE500AN. It allows programming a different code to any of its four buttons.
Programming: At first, refer to opener, control board or external receiver manual to locate the respective programming button (Fig. 2).
Also refer to the respective "Program your opener and remote control" or "Radio" section in this manual.
Step1: To enter the universal remote controls programming mode:
Push and hold left and right button on the universal remote control simultaneously until its LED goes constantly on for approx. 30 sec (=
time frame for programming).
Step 2: Now push programming button on the opener, control board or external receiver. The respective programming LED will go on
constantly (also refer to opener, control board or external receiver manual).
Step 3: Select a button on the universal remote control, push it repeatedly until the programming LED responds (also refer to opener,
control board or external receiver manual to learn how the respective programming LEDs respond). Proceed with Step 4.
Step 4: Push a different button on the universal remote control to exit (LED goes off) its programming mode.
Delete a remote control (also refer to opener, control board or external receiver manual): Push the programming button on the opener,
control board or external receiver until its programming LED goes off.
In case of programming failure:
Time frame for programming expired. Repeat programming starting with step1. Step 4 was not executed.
Device not compatible (check compatibility on www.chamberlain.eu or www.liftmaster.eu)
Our electrical and electronic equipment may not be disposed of with household waste and must be disposed of after use
properly in accordance with WEEE Directive EU: 2012/19/EU; GB UK(NI): SI 2012 nr. 19 on waste electrical and electronic
equipment in order to ensure that materials are recycled. Collecting waste electrical equipment separately means environmen-
tally-friendly disposal and is completely free of charge for the consumer.
WEEE reg. no. in Germany: DE66256568.
Any waste packaging left over with the end consumer must be collected separately from mixed waste, in accordance with the Directive.
Packaging may not be disposed of with household waste, organic waste or in nature. Packaging material must be separated according to
its material and disposed of in the recycling containers provided and in certain council recycling bins.
Our batteries are marketed in compliance with the law. The 'crossed-out waste bin' indicates that batteries may not be
disposed of with household waste. Batteries included in the product (technical data). In order to avoid causing harm to the
environment or people's health, used batteries must be returned for regulated disposal at council recycling centres or via retail
outlets, as is prescribed by law. Batteries may only be brought for disposal once fully discharged and, in the case of lithium batteries, with
their terminals taped over. The batteries can be easily removed from our equipment for disposal.
Registration number in Germany: 21002670.
Hereby, Chamberlain GmbH declares that the radio equipment type TX4RUNI is in compliance with Directive 2014/53/EU, 2014/30/EU,
2014/35/EU. The full text of the EU declaration of conformity is available at the following internet address:
https://doc.chamberlain.de/
Specifications
Frequency
Transmitting power
Battery
433.30MHz, 433.92MHz, 434.54MHz
CR2032 / 3V
< 10mW
en
4