Technical Specifications - Lorelli DAILY COMFORT Gebrauchsanweisung

Problem: I experience pain when I use the breast pump.
Solution: One of the reasons can be the too high vacuum level. Maybe you don't need the full vacuum power of the breast pump. At
first use the Massage mode as a massage stimulation and after that you can use the express mode. If you still feel a pain, stop using
the breast pump and consult your breastfeeding advisor. If the pump does not come away easily from the breast, it may be necessary
to break the vacuum by placing a finger between the breast and Massage Cushion.
Problem: The breast pump does not work.
Solution: First check if you have assembled the breast pump correctly and make sure that there is no kink in the tube. To prevent
interference keep other electric equipment, like mobile phone or laptop, away from the breast pump while expressing. Check the
battery or if you are using the breast pump on electrical power, check to make sure you are using the adapter that was supplied with
the product.
Problem: I do not feel any suction.
Solution: Check if you have assembled the breast pump correctly by following the steps in section 'preparing for use'. Make sure that
the silicone tube is firmly attached to the motor unit and to the cap and diaphragm. Also make sure that the pump is positioned
correctly on the breast to allow for vacuum to occur.
Problem: The pump has too much suction.
Solution: Follow below guidelines if you experience too much suction with your breast pump:
Make sure you only use the parts recommended from the manufacturer.
Make sure you have assembled the breast pump with the massage cushion: not using the massage cushion can result in too much
vacuum.
When using a breast pump for the first time, you may experience the suction level as too high at first. Practicing can help. If the
problem persists, consult your breast feeding advisor.
Problem: I need to replace the silicone tube, but do not know how to remove it.
Solution: To remove the tube, grab it close to the motor unit and pull while twisting it. To reconnect the tube, ease the tube back onto
the connector on the motor unit with a slight twisting motion. Make sure it is securely attached.
Problem: I encounter back flow issue during pumping.
Solution: Immediately shut off the breast pump and remove the tubs. Clean all parts and the tubing and make sure it's fully dry before
using it. If the breast milk haven't enter the breast pump motor, you can continue using it, make sure that you assemble the silicone
diaphragm & cap tightly. Please contact the manufacturer if breast milk has enter the motor & do not continue to use it.
Keep the breast pump out of direct sunlight as prolonged exposure may cause discoloration.
Store the breast pump and its accessories in a safe, clean and dry place.
If the appliance has been stored in a hot or cold environment, place it in the usage environment to let it reach a
temperature within the usage conditions ( 10°C to 30°C ) before you use it.
Sucking power: 60mmhg--280mmhg
Noise limited: <60dB
：
Fixed time 30 minutes
Lithium battery 3.7V 1800mAh
IP Class: IPX0
Environmental Conditions for Operation Temperature 10-30 , Relative humidity 15%-93%, Atmospheric
pressure 700-1060hpa
Environmental Conditions Storage Temperature -25-50
pressure 700-1060hPa
Adapter input: AC 100–240V; 50/60Hz 0.2 A max; Output: DC 5.0V, 5W,1.0A
TROUBLESHOOTING
USAGE AND STORAGE CONDITIONS

TECHNICAL SPECIFICATIONS

：
：
℃
℃，
Relative humidity 15%-93% Atmospheric
10
，