Klipsch GIG XL Bedienungsanleitung Seite 15

Note: This equipment has been tested and found to comply
with the limits for a Class B digital device, pursuant to part 15 of
the FCC Rules. These limits are designed to provide reasonable
protection against harmful interference in a residential
installation. This equipment generates, uses, and can radiate radio
frequency energy and, if not installed and used in accordance
with the instructions, may cause harmful interference to radio
communication. However, there is no guarantee that interference
will not occur in a particular installation. If this equipment does
cause harmful interference to radio or television reception, which
can be determined by turning the equipment off and on, the user
is encouraged to try to correct the interference by one or more of
the following measures:
• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and receiver.
• Connect the equipment into an outlet on a circuit different from
that to which the receiver is connected.
• Consult the dealer or an experienced radio/TV technician for
help.
Caution: Changes or modifications not expressly approved by
Klipsch Group, Inc. could void the user's authority to operate the
equipment
FCC Radiation Exposure Statement
This equipment complies with FCC radiation exposure limits set
forth for an uncontrolled environment. This equipment should be
installed and operated with minimum distance 20cm between the
radiator & your body. This transmitter must not be co-located or
operating in conjunction with any other antenna or transmitter.
Industry Canada Regulatory Information
This device contains license-exempt transmitter(s)/receiver(s)
that comply with Innovation, Science and Economic Development
Canada's license-exempt RSS(s). Operation is subject to the
following two conditions:
(1) This device may not cause interference.
(2) This device must accept any interference, including
interference that may cause undesired operation of the device.
Industry Canada Regulatory Information
CAN ICES-003 (B)/NMB-003 (B)
IC Radiation Exposure Statement: This equipment complies
with IC radiation exposure limits set forth for an uncontrolled
environment. This equipment should be installed and operated
with minimum distance 20cm between the radiator & your
body. This transmitter must not be co-located or operating in
conjunction with any other antenna or transmitter.
EU / UK COMPLIANCE INFORMATION
Operation frequency band (Bluetooth): 2402 MHz - 2480 MHz
Max. transmitted RF power < 10 dBm
Eligible to bear the CE mark; Conforms to European Union Low
Voltage Directive 2014/35/EU; European Union EMC Directive
2014/30/EU; European Union Restriction of Hazardous Substances
Recast (RoHS) Directive 2011/65/EU; European Union WEEE Direc-
tive 2012/19/EU;European Union Eco-Design Directive 2009/125/
EC; European Union Registration, Evaluation, Authorization and
Restriction of Chemicals (REACH) Directive 2006/121/EC; European
Union Radio Equipment Directive (RED) 2014/53/EU.
Hereby, Klipsch Group Inc. declares that this product is in compli-
ance with the essential requirements and other relevant provisions
of Directive 2014/53/EU.
You may obtain a free copy of the Declaration of Conformity by
contacting your dealer, distributor, or Klipsch Group, Inc.'s worldwide
headquarters. Contact information can be found here:
http://www.klipsch.com/Contact-Us
EU importer: Klipsch Group Europe B.V.
Address: Kapteynstraat 1, 2201 BB, Noordwijk, the Netherlands
UK importer: Henley Audio Ltd.
Address: Unit B, Park 34, Collett, Didcot, Oxfordshire, OX11 7WB
WEEE NOTICE
Note: This mark applies only to countries within the European Union
(EU) and Norway.
This appliance is labeled in accordance with European
Directive 2012/19/EU concerning waste of electrical and
electronic equipment (WEEE). This label indicates that this
product should not be disposed of with household waste.
It should be deposited at an appropriate facility to enable recovery
and recycling.
14