Ultenic T10 Bedienungsanleitung Seite 6

�. Remote control
Mopping Mode
Spot Cleaning
Decrease Suction Power
Note:
�. It is recommended to point the remote to the front of the Robot for best results.
�. The remote control range is �-� meters (��-�� feet).
Using Your Robot
�. Setting up the Auto Empty Base
About your Auto Empty Base
The Auto Empty Base is designed to automatically empty and charge the Ultenic robot vacuum
cleaner T10. Plug the power cable into the back panel of the Base and plug the other end in a
functioning wall outlet. Place on a flat, hard surface at least 2.5 inches away from the wall.
Ensure that there is a clear space in front and both sides so that your T10 can return to Base to
recharge and empty.
Back to Home
Manual Navigation Directional Keys
Start/ Pause
Mute
Increase Suction Power
Max suction
Less than or equal to 3-6 meters
How to place your Auto Empty Base
2.5 inches from the wall
Note:
�. Place the Auto Empty Base where the robot can easily access.
�. The Auto Empty Base must always remain connected to power. Avoid using a power source that
may inadvertently be switched off.
�. Setting up the Robot
Step �:
Position the Robot on the floor near your Auto Empty Base. Press and hold the "
until the indicator turns blue. You will hear a welcome message.
Note:
Voice prompt volume can be adjusted later in the Ultenic App or muted using the remote control.
Step �:
Press the " " Home button to pair the Robot to your Auto Empty Base. The Robot will navigate
and dock to the base. Allow the Robot to fully charge before first use.
Note:
Dust collection may activate during initial docking. Do not be alarmed. Dust collection frequency can
be adjusted later in the Ultenic App.
�. Getting Started
Before using this product, please clear the floor of all objects other than furniture as some small
objects may obstruct, get caught in, or damage your Robot.
Use Your Robot with the Ultenic App
To fully enjoy all the available features, it is recommended to control your Robot via the Ultenic app.
Before you start, make sure that:
· Your smartphone or tablet is connected to a Wi-Fi network.
· Your smartphone or tablet is running iOS �.� (or above) or Android �.� (or above).
· The �.�GHz band wireless signal is enabled on your wireless router.
" Power button