Replacing Batteries; Technical Characteristics - urmet bitron video AV2009/07 Gebrauchsanweisung

ENGLISH
INSTALLATION
1) Open the keypad by pressing the lower flap and lifting the lid as shown in fig. 1.
Insert the batteries (exclusively at the time of acquisition) observing polarity (fig. 2).
For keypad acquisition and configuration, refer to the AV2009/01 Installation Manual.
2) Fasten the keypad to the wall using fastenings "A" shown in fig. 3.

REPLACING BATTERIES

To replace the battery, open the keypad and remove the batteries. Replace them and take the used
batteries to an authorised disposal centre. The data programmed remains after battery replacement.

TECHNICAL CHARACTERISTICS

Power Supply ............................................................................................ 2 3V CR123A Lithium/Manganese
Radio range ................................................................................................................. Up to 300m in open air
Radio transmission ..........................................................................frequency modulation FSK-NB, 434 MHz
Battery's life ........................................................................................... 3 years in conditions of standard use
Degree of protection ....................................................................................................................... IP30 / IK02
Operating temp.......................................................................................................................... +5°C ÷ +40°C
Dimensions (l x h x d) mm ........................................................................................................ 138 x 106 x 35
Autoprotection against opening and removal.
DS902009-006
All manuals and user guides at all-guides.com
Dioxide batteries (supplied)
Formats: CR17345 (IEC), 5018LC (ANSI)
3