Westfalia 64 16 05 Originalanleitung Seite 14

Dust Collection Bag/Dust Extractor/Vacuum Cleaner
Please Notice! Grinding some material can lead to the formation of hazardous
or explosive dust. During operation a dust extractor or a suitable vacuum
cleaner should be attached, or at least the included dust collection bag (4)
should be used.
1. For attaching the suction hose of a dust extractor or vacuum
cleaner, use the included adaptor (6).
2. Attach the adaptor to the extraction flange of the housing.
The adaptor is equipped with bayonet lock. Firmly push the
adaptor with the black rubber ring to the extraction flange
and turn clockwise to lock.
3. Connect the adaptor to the vacuum hose or the included durst collection bag
(4). To attach the dust collection bag, squeeze the spring wire rings together
and slide the spring wire rings over the adaptor. To detach the dust collection
bag, press the spring wire rings together and remove the dust bag.
Attaching and Replacing the Sanding Arm
1. First, unplug from power mains. Slacken the tension of the sanding belt by
folding down the tensioning lever and remove the sanding belt as described
in the chapter "Installing/Replacing the Sanding Belt".
2. Swing the tensioning lever back to extend the sanding arm all the way. Loosen
the regulating turn knob until the sanding arm is free. Slide it out of the unit
and insert the other sanding arm.
3. Tighten the sanding arm with the regulating turn knob until the arm is straight
in the unit. Make sure the spring is placed correctly between the sanding arm
and the sanding arm holder.
4. Fold the tensioning lever forward and insert the suitable sanding belt. Tension
the sanding belt with the tensioning lever and switch on the power file. Finally
adjust the sanding belt with the regulating turn knob.
Hints on the safe use of the Power File
 If possible, place the work pieces in a vice or secure them to a workbench or
other solid base.
 When using the file on wood, it should be used in the direction of the fibres
whenever possible to avoid ripping fibres from the wood.
 If very wide work pieces are machined, it is advisable to align the machine in
such a way that it covers as much of the surface as possible at the same time
to achieve a smooth and level surface.
14