Programming Access Codes (First Time) - Siemens Bewacom BM3 Bedienungshandbuch

16
Programming access codes (first
time)
Four different 4-digit entrance codes can be pro-
grammed.
1 Set Bewacom to programming mode.
2 Press 0000.
3 Enter the desired access code using 4 digits.
4 Enter the code once again.
5 If the code is not to be time controlled, press 0.
If the code is to be time controlled, select the
desired input (see below).
1 = the code can be timed from a time clock
connected to input 1.
2 = the code can be timed from a time clock
connected to input 2.
Also see the wiring diagram.
6 Follow steps 2-5 to programme the next code.
7 Press B to exit programming.
BM3 Installation & User Manual