Start-Up; Installation On The Ground, Using The Ground Spike; Installation On A Wall Using A Screw / Peg - Parkside PTUS 1 A1 Bedienungs- Und Sicherheitshinweise

Start-up

The product is protected against splash water and is also suitable for
outdoor use. There are two possible installation options:
Installation on the ground, using
the ground spike
The enclosed ground spike
comes in three parts (see Fig. C), but for low installation heights,
one part can be used on its own. Never place the product directly
onto the ground: it can be flooded in heavy rain.
Push the point of the ground spike
use force.
Screw the open end of the ground spike
the ground spike
Point the product, so that the motion sensor
wards the area you wish to monitor. Make sure that the area
you wish to monitor is not blocked by objects, such as trees or
garden furniture.

Installation on a wall using a screw / peg

Use the enclosed peg
the product on a wall. This installation material is intended for a
normal wall. If the wall you wish to install the product on has a
and ground spike connector
12
.
9
(Ø 6 mm) and the screw
14
into soft earth. Never
12
into the holder for
12
is pointed to-
5
15
GB/IE/NI
13
to install
15