Automatic Shutdown Function; Maintenance; Maintenance Schedule - Husqvarna 120iTK4-H Bedienungsanweisung

4. Move the cutting attachment to the correct angle.
5. Release the lock buttons (A) at the 2 sides.
6. Move the housing (B) up and down until the cutting
attachment locks in position.
To start the SavE function
The product has a SavE function. The SavE function
gives the longest operation time from the battery.
1. Push the SavE button. The LED comes on to show
that the function is on.
2. Push the SavE button again to stop the SavE
function.
Introduction
WARNING:
safety chapter before you do maintenance
work on the product.
WARNING:
you do maintenance on the product.

Maintenance

Clean the external parts of the product.
Examine that the start and stop switch works correctly and is not damaged.
Make sure that the power trigger and the power trigger lockout function correctly
from a safety point of view.
Make sure that all controls work and are not damaged.
Make sure that the cutter blade and cutter guard have no cracks and that they
are not damaged. Replace the cutter blade or the cutter guard if they have
cracks or if they have been exposed to impact.
Replace the cutter blade if it is bent or damaged.
Make sure that the screws and nuts are tight.
Make sure that the battery is not damaged.
Make sure that the battery is charged.
1553 - 007 - 01.07.2022
Maintenance
Read and understand the
Remove the battery before

Automatic shutdown function

The product has an automatic shutdown function that
stops the product if it is not used. The green LED for
start/stop indication goes off and the product stops after
60 seconds.
To stop the product
1. Release the power trigger.
2. Push and hold the start/stop button until the green
LED goes off.
3. Remove the battery from the product. Push the 2
release buttons and pull out the battery.

Maintenance schedule

The following is a list of the maintenance steps that you
must do on the product.
Before
use
X
X
X
X
X
X
X
X
X
Weekly Monthly
13