1. Hold the knob (A) on the weight with one hand.
A
B
Introduction
WARNING:
maintenance, you must read and
understand the safety chapter.
For all servicing and repair work on the product, special
training is necessary. We guarantee the availability of
professional repairs and servicing. If your dealer is not
a service agent, speak to them for information about the
nearest service agent.
General product maintenance
Clean the product.
Do a check of all safety devices.
Make sure that nuts and screws are tight.
Do a check of the brush sealing for damages and wear.
Clean the electrical enclosure.
Do a check of the electrical components, the cables and
the connections for wear and damages.
Do a check of the hose connections. Do a check of all
hoses on the product for damages or leakage.
Make sure that the dust hoses are not damaged and free
of blockage.
Make sure that the dust collector is empty and connected
correctly.
Do a check of the grinding discs for damages and wear.
Do a check of the emergency stop button.
20
Maintenance
Before you do
2. Pull out the locking pin (B) with the other hand.
3. Move the weight to selected position. Refer to
Weights BMG 780 RC on page 19 .
4. Put back the locking pin.
5. Do the same procedure on the opposite side of the
product.
Maintenance schedule
* = General maintenance done by the operator. The
instructions are not given in this operator's manual.
X = The instructions are given in this operator's manual.
O = The instructions are not given in this operator's
manual. Let an approved service agent do the
maintenance.
Daily
Weekly
X
*
*
*
*
*
*
*
*
X
Each 3
Yearly
months
X
1811 - 001 - 02.05.2022