Husqvarna BS 75 Bedienungsanweisung Seite 9

9. Adjust the handle to an applicable operation position.
To adjust the handle height on page 9
Refer to
To adjust the adjustable handle on page 9 .
and
10. Make sure that the drive wheels are engaged. Refer
To engage and disengage the drive wheels on
to
page 21 .
11. Install a blade. Refer to
dimension and installation position on page 9 .
WARNING:
The blades are very sharp.
12. Make sure that the blade is sharp. If it is necessary,
replace or sharpen the blade. Refer to
the blade on page 17 and To sharpen the blade on
page 17 .
13. If you use a self-scoring blade, make sure that the
angles at the ends of the blade (A) are sharp.
14. Make sure that the start/stop and function selection
switch is in the "0" position.
15. Connect the product to a power supply. Refer to
connect the product to a power supply on page 10 .
1804 - 001 - 06.05.2022
To select the correct blade
Use protective gloves.
To replace
A
To adjust the handle height
1. Loosen the handle adjustment knob.
2. Move the handle to an applicable position.
3. Tighten the handle adjustment knob.
To adjust the adjustable handle
1. Loosen the clamp lever.
2. Move the adjustable handle to an applicable
position.
To
3. Tighten the clamp lever.
To select the correct blade dimension
and installation position
WARNING:
blades are very sharp.
Use protective gloves. The
9