Husqvarna BS 75 Bedienungsanweisung Seite 21

7. Lift the product by the handle until all 3 wheels are
on the floor.
8. Push the product slowly.
To engage and disengage the drive
wheels
The drive wheels are engaged when the locking pin is in
the inner hole and disengaged when the locking pin is in
the outer hole.
1. Tilt the product until the foot support and the handle
are on the floor.
2. Turn the wheels until the 2 holes are aligned and pull
out the locking pin.
3. Put the locking pin in the inner hole to engage the
drive wheels.
4. To disengage the drive wheels, put the locking pin in
the outer hole.
1804 - 001 - 06.05.2022
To move the product up and down a
ramp
WARNING:
move the product up and down ramps with
the motor on. The product is heavy and
there is a risk of injury if the product falls
or moves too quickly.
WARNING:
slope, always use a winch. Do not stay
below or near the product.
WARNING:
on steep slopes. Look at the rating plate
on the product for information about the
maximum slope angle.
• To move the product down a ramp, operate the
product rearward slowly.
• To move the product up a ramp, operate the product
forward slowly.
• Do not turn the product more than 45° on a ramp.
To lift the product
WARNING:
equipment has the correct specification to lift
the product safely. The rating plate on the
product shows the product weight.
WARNING:
or near a lifted product. Keep bystanders
away from the risk area.
WARNING:
product. Make sure that the lifting point is
correctly installed and not damaged.
WARNING:
the handlebar, motor or chassis.
Be very careful when you
For ramps with a steep
Do not move the product
Make sure that the lifting
Do not walk or stay below
Do not lift a damaged
Do not lift the product by
21