Husqvarna BS 75 Bedienungsanweisung Seite 12

To stop the product
1. Turn the speed control counterclockwise to the
lowest speed.
2. Release the drive levers.
3. Turn the start/stop and function selection switch to
the "0" position.
4. Stop the dust extractor.
5. Disconnect the power supply.
To remove a soft floor surface
WARNING:
blades are very sharp.
Note:
Short blades cut the floors easier than long
blades. Long blades are not always better or faster. A
short blade usually cleans the floor better than a wide
blade.
Note:
The blades are sharp for a longer time if the
work area is clean from unwanted material.
1. Use personal protective equipment. Refer to
Personal protective equipment on page 6 .
2. Install a self scoring blade. Refer to
correct blade dimension and installation position on
page 9 and To replace the blade on page 17 .
12
Use protective gloves. The
To select the
WARNING:
The blades are very sharp.
3. Make sure that the blade is sharp. Sharpen the
blade if it is necessary. Refer to
blade on page 17 .
4. Cut a linear ditch in the floor.
5. Install a flat blade.
WARNING:
The blades are very sharp.
6. Start at the ditch and remove the floor.
1
To remove a hard floor surface
WARNING:
blades are very sharp.
Note:
Short blades cut the floors easier than long
blades. Long blades are not always better or faster. A
short blade usually cleans the floor better than a wide
blade.
Note:
The blades are sharp for a longer time if the
work area is clean from unwanted material.
1. Use personal protective equipment. Refer to
Personal protective equipment on page 6 .
Use protective gloves.
To sharpen the
Use protective gloves.
2
Use protective gloves. The
1804 - 001 - 06.05.2022