Cleaning/Maintenance; Cleaning & Maintenance; General Cleaning Work; Cleaning The Wire Filter Basket And Pleated Filter - Parkside PAS 500 D2 Originalbetriebsanleitung

Cleaning/Maintenance

Pull out the mains plug.
Danger of electric shock.
Never hose the appliance down
with water. Never use aggressive
cleaning agents or solvents. This
could damage the appliance.
If the single-use thermal fuse has
permanently disconnected the pow-
er circuit, the device must be sent to
a service centre for repair.

General Cleaning Work

Clean the equipment after each
use:
• Carry out cleaning outside in order to
avoid mess.
• Take off the container lid (
empty the metal container (
Clean the metal container with water
and allow it to dry.
• After removing the suction hose (
11), clean the dust and soot particles
from the connections. This ensures that
the suction hose can be inserted again
easily.
• Clean the wire filter basket and the
pleated filter (see below).
Cleaning the Wire Filter
Basket and Pleated Filter
Replace the pleated filter if it is
worn, damaged or heavily soiled
(see "replacement parts").
1. Take off the container cover (5).
2. Turn the wire filter basket (14)
anticlockwise and take it off.
5) and
10).

Cleaning the Air Filter

Tap out the wire filter basket.
3. Tap out the pleated filter (13)
and clean it with a paintbrush
or hand brush.
Don't wash the pleated
filter in water.
4. Place the pleated filter (13) on
the rotated container lid (5) (see
small image
Here, the
rubber ring
must be on
the contain-
er lid and
press the
safety stop switch (15a) down-
wards.
5. Pull the wire filter basket (14)
over the pleated filter (13) and
turn it clockwise until it stops.
The safety stop (15b) must be
pressed down.
If there is play in the wire filter bas-
ket (14), use a finger to press down
the metal lugs (16).
1. Take off the container cover (5),
wire filter basket (
pleated filter (
2. Take the air filter (17) out of the
filter housing (18).
3. Clean the filter with soap and
water and allow it to dry in the
air.
4. Place the air filter (17) back in
the filter housing (18).
GB
).
0mm
15b 15a
14) and
13).
43