Jump Starting Via Direct Connection To The Battery - Westfalia 82 86 84 Bedienungsanleitung

Jump Starting via direct Connection to the Battery

1. Make sure that all consumers on the "dead" car, such as ignition,
lights, radio, air condition, heater etc. are turned off.
2. Open and fix the engine hood of the vehicle to be charged.
3. Remove the charging cable (19) from the storage tray (8) and put
the cigarette lighter plug (18) into the cigarette lighter socket (12)
which is located under the rubber cap (4).
4. First attach the red clamp of the charging cable to the plus pole (+)
respectively the positive terminal of the dead battery. Then attach
the black clamp to an earthed contact of the vehicle's body. Most
vehicles are equipped with a corresponding point close to the
battery.
5. Rapidly step with your foot on the pedal
(1). The charging indicator (3) lights up
while the pedal is operated. Always floor
the pedal completely. Repeat this step for
2 – 5 minutes.
6. Remove the charging cable from the
vehicle and start the engine of the vehicle.
If the motor does not start, repeat the jump
starting procedure.
All manuals and user guides at all-guides.com
Operation
21