Mechanical Locking; Wiring; Quick Wiring Guide - Endress+Hauser RSG30 Ecograph T Kurzbedienungsanleitung

Wiring

3.3

Mechanical locking

The CompactFlash card can be secured
against unauthorized removal using the
locking plate supplied. For this purpose,
insert the locking plate into the slit below the
handle of the cover plate (see Fig. 2). Now
you can lead-seal or seal the cover plate with
a suitable lock.
4 Wiring
4.1

Quick wiring guide

#
Warning!
Please note that the entire electrical connection may only take place when the device is de-ener-
gized.
"
Caution!
• The ground connection must be made before all other connections. Any interruption in the
ground can cause danger.
• Before commissioning, compare the supply voltage with the information specified on the
nameplate (left-hand side of the housing).
• The mixed connection of safety extra-low voltage and dangerous contact voltage to the relay
is not permitted.
• Provide a suitable switch or circuit breaker when installing in a building. This switch must be
installed near to the device (easily accessible) and be labeled as a separator.
• An overcurrent protective device (nominal current ≤ 10 A) is required for the power cable.
!
Note!
Please also refer to the terminal diagram on the rear of the device.
20
Fig. 2: Inserting the locking plate
Multi Channel Recorder