Before Installing This Product; Installation With The Holder; Installation Using The Screw Holes On The Side Of This Product; Installing The Microphone - Pioneer SPH-T20BT Benutzerhandbuch

Before installing
this product
1
Remove the trim ring.
Extend top and bottom of the
trim ring outwards to remove
the trim ring.
Trim ring
2
Insert the supplied
extraction keys into both
sides of the unit until they
click into place.
3
Pull the unit out of the
holder.
Extraction key
Installation with the
holder
1
Install the holder into the
dashboard.
2
Secure the mounting sleeve
by using a screwdriver to
bend the metal tabs (90°)
into place.
182 mm
112 mm
Dashboard
Holder
3
Install this product into the
holder.
Dashboard
4
Attach the trim ring.
Trim ring
Groove
Attach the trim ring with the
side with a groove facing
downward.
Installation using
the screw holes
on the side of this
product
1
Fastening this product to the
radio-mounting bracket.
Position this product so that its
screw holes are aligned with the
screw holes of the bracket, and
tighten the screws at 3 locations
on each side.
Use either the truss head
screws or flush surface screws,
depending on the shape of the
bracket's screw holes.
Radio-mounting bracket
If the pawl interferes with
installation, you may bend it
down out of the way.
Dashboard or console
Truss screw or tapping screw
Be sure to use the screws
supplied with this product.
Installing the
microphone
The microphone should be placed
directly in front of the driver at a
suitable distance to pick up their
voice clearly.
En
15